Cylinder Head Gasket: Remove & Replace
WARNING: This page is about the Corona Base, 2D Hardtop, Automatic Trans, which is a different variant/trim than selected.
Includes: Remove carbon and check surfaces for warpage. Includes adjust Valves (where applicable) and clean and adjust Spark Plugs.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| In-Line4, w/EGR | 6.0 | B | ||
| In-Line4, w/o EGR | 5.5 | B | ||
| Additional Procedure: CYLINDER HEAD GASKET: Remove & Replace: | ||||
| Where Air Cond interferes add | 0.5 | B | ||
| Combination Procedure: VALVE: Grind: | ||||
| One | 0.4 | A | ||
| Combination Procedure: VALVE SPRING OR SEAL: Replace: | ||||
| 2 VPC, Each Cyl | 0.1 | B | ||