LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1973 >> Pickup Automatic Trans >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> TOYOTA Engines - (8R-C & 18R-C Engines) 4 Cylinder >> 1969-73 TOYOTA (8R-C & 18R-C Engines) 4 Cylinder >> Engine Removal

Engine Removal

  1. Drain coolant and engine oil, disconnect battery cables. If equipped with auto, trans., drain fluid. Unscrew hinge bolts and remove hood.
  2. Remove air cleaner and disconnect heater hoses, fuel lines and all engine wiring. Disconnect flexible cable to carburetor and remove bracket holding cable to cylinder head cover. Disconnect vacuum hoses to emission control and mark them for reinstallation. Make sure to disconnect throttle retard hose connection at base of carburetor.
  3. Disconnect vacuum line for brake booster at intake manifold. If equipped with air conditioning, disconnect lines at compressor. Disconnect plug-in for electric clutch.
  4. Remove baffle between radiator and front suspension to gain access to lower radiator hose and auto, trans, hoses. Remove radiator and auto, trans, cooler hoses. Remove fan shrouds and grille, radiator baffle, and radiator. Remove condenser lines and condenser.
    NOTE: On some Corona Mark II vehicles, it is necessary to remove headlight assemblies to remove condenser.
  5. Remove hood lock support, disconnect clutch hose bracket (if equipped). Remove front engine mount attaching bolts. Engine will rest on mounts.
  6. Disconnect exhaust pipe from exhaust manifold and disconnect support bracket from side of transmission. Remove clutch cylinder (if equipped). Remove support bracket for parking brake equalizer.
  7. Disconnect speedometer drive cable, transmission linkage and driveshaft. Remove rear engine support after placing jack under engine and removing engine mounting bolts and crossmember. Engine will rest on jack. Remove engine using engine hoist. To install, reverse removal procedure.
scientia non olet · About LEMON Manuals