LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1967 >> Crown 2.3L Eng, Not Available Trans >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> TOYOTA Engines (M, 2M & 4M) 6 Cylinder >> Engine Cooling >> Water Pump >> Bearing Replacement

Bearing Replacement

  1. Remove rotor and heat cover to about 176°F. Using a press and suitable tool (SST 09623-36010), force bearing out of cover.
  2. Place bearing on suitable tool (SST 09236-36010) and place tool into service hole at coupling center. Using press, force bearing out from coupling end.
  3. With cover heated to about 176°F, force bearing in using press and suitable tool (SST 09236-36010). Do not attempt to install by pressing bearing shaft. Press in until bearing end surface is flush with cover end surface.
  4. Place gasket and seat into cover and press onto bearing. Coat contact surfaces of seat and thrust washer with 1 or 2 drops of silicone oil. Do not use other lubricants.
  5. Using suitable tool (SST 09236-36010), press coupling onto bearing. Coat coupling case mounting surface with liquid sealer and install coupling case. Fill with silicone oil and install pump.
scientia non olet · About LEMON Manuals