LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1967 >> Crown 2.3L Eng, Not Available Trans >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> TOYOTA Engines (M, 2M & 4M) 6 Cylinder >> 1965-73 TOYOTA (M, 2M & 4M Engines) 6 Cylinder >> Valve Springs >> Installation

Valve Springs: Installation

To install valve springs, reverse removal procedure. Install new valve stem oil seals, making sure there is approximately 0.008 - 0.020" (0.2 - 0.5 mm) clearance between seal and plate washer. Long seal is installed on intake valve and short seal is installed on exhaust valve.

scientia non olet · About LEMON Manuals