Cylinder Head Removal
- Remove intake and exhaust manifolds as previously outlined. Drain engine cooling system and remove valve cover. Remove rocker arm assembly.
- Disconnect spark plug wires at spark plugs. Remove push rods and mark or position them to insure that they are installed in same valve tappet.
- Remove cylinder head bolts in sequence shown in illustration and remove cylinder head. To install, clean mating surfaces, use new gasket and tighten bolts to specifications in sequence shown in illustration.
- Reverse removal procedure to install remaining components. Tighten all bolts and nuts to specifications and adjust valve clearance.
VALVES
| Engine & Valve | Head Diam. | Face Angle | Seat Angle | Seat Width | Stem Diameter | Stem Clearance | Valve Lift | |
|---|---|---|---|---|---|---|---|---|
| All | ||||||||
| Int. | 1.65" | 45° | 45° | .055" | 3.54" | .001-.002" | ..... | |
| Exh. | 1.38" | 45° | 45° | .055" | 3.54" | .0016-.0028" | ..... | |