Seat Back - 2nd Row - LH - Remove And Replace: Install
- Position the LH 2nd row seat back into the vehicle, and then secure the seat back into the RH pivot.
- Slightly tilt the LH 2nd row seat back upward, and then press the LH 2nd row pivot cast downward to secure it to the pivot bracket.
- Install the pivot bushing that attaches the LH 2nd row seat back assembly to the pivot bracket.
- Fasten the clip that attaches the LH 2nd row seat back harness to the pivot bracket.
- Connect the LH 2nd row seat back harness electrical connector.
- Fold the LH 2nd row seat to the up position.
- Install a new bolt that attaches the 2nd row center seat belt lower anchor to the vehicle.
25 N.m (18.4 ft-lbs)
Tip: Use of the following tool(s) is recommended:
- 15 mm socket
- Install the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove And Replace) .
- Install the LH and RH 2nd row seat outer bolsters. See Bolster - Outer - Seat - 2nd Row - LH (Remove And Replace) .
- Move the front seats to the original positions.
- Raise all the windows and close all the doors.