Closeout Panel - Door - Front - LH - Remove And Replace: Install

Route the latch cable grommet through the opening in the LH front door closeout panel, and then install the grommet into the closeout panel assembly.

Courtesy of TESLA, INC.

Courtesy of TESLA, INC.

Courtesy of TESLA, INC.
Install the bolts (x6) that attach the LH front door closeout panel to the door assembly.
Torque 4.5 N.m

Tip: Use of the following tool(s) is recommended:
- 8 mm socket
- 2 in extension
Courtesy of TESLA, INC.
Fasten the clips (x2) that attach the wiring harness onto the LH front door closeout panel assembly.
NOTE: Make sure there is an audible click to fully engage the clip.

Courtesy of TESLA, INC.
Connect the LH front door pressure sensor electrical connector, and then engage the connector lock.

Courtesy of TESLA, INC.
Install the LH front door handle controller onto the LH front door closeout panel assembly.

Courtesy of TESLA, INC.

Courtesy of TESLA, INC.
Install the screw that attaches the LH front door handle controller to the LH front door closeout panel.
Torque 2 N.m

Tip: Use of the following tool(s) is recommended:
- Torx T25 socket
- Flex head ratchet/flex head torque wrench
- 2 in extension
Courtesy of TESLA, INC.
Connect the LH front door handle controller electrical connector, and then engage the connector lock.

Courtesy of TESLA, INC.
Install the LH front door trim panel. See Panel - Door Trim - Front - LH (Remove and Replace)
Install the LH front door trim decor. See Decor - Trim - Front Door - LH (Remove and Replace)
Raise the LH front window and close the LH front door.