Touchscreen - HW4 - Remove And Replace: Install
- Install the touchscreen pivot mechanism. See Mechanism - Pivot - Touchscreen - Remove And Replace .
- Position the touchscreen ground strap on the touchscreen, and then install the bolt that attaches the strap to the touchscreen.
4 Nm (2.9 lbs-ft)
CAUTION: Failure to re-connect the ground strap will result in display functionality issues.NOTE: Inspect the ground strap bolt and replace if damaged.Tip: Use of the following tool(s) is recommended:
- Mini Ratchet Bit Set
- Torque Wrench 1/4in Dr Hexagon - 1060071-00-A
- Position the touchscreen lower shroud cover on the touchscreen, and then install the tabs (x3) that attach the cover to the touchscreen.NOTE: Slide the lower shroud cover downwards until the tabs fully engage.
- Position the touchscreen and pivot mechanism on the instrument panel carrier, and then route the display harness behind the LH side of the touchscreen pivot mechanism.
- Connect the touchscreen coax and power connectors (x2), and then install the clip that attaches the harness to the touchscreen pivot mechanism arm.NOTE: Replace the clip if it is damaged.
- Position the touchscreen shroud behind the touchscreen, and then install the tabs (x3) that attach the shroud to the touchscreen.NOTE: Slide the display downwards until the tabs fully engage.
- Install the bolts (x2) that attach the touchscreen to the instrument panel carrier.
Tip: Use of the following tool(s) is recommended:
- 2 in extension
- 10 mm socket
- Ratchet/torque wrench
- Connect the touchscreen motor connectors (x2).NOTE: Slide the touchscreen fully into the instrument panel brackets after securing the connectors.
- Install the instrument panel service panel. See Service Panel - Instrument Panel (Remove And Replace) .
- Connect LV power. See LV Power - Disconnect And Connect .
- Move the RH front seat to original position.
- Connect a laptop with Toolbox 3 to the vehicle. See Toolbox 3 - Connect And Disconnect .
- In Toolbox, click the Actions
tab, type "display" into the search field, click Display Actuator Test
, click Run
, and then allow the routine to complete.NOTE: Select 'X' at top right of window to close once calibration is successful. Check mechanism wiring and connections if failed.
- Click Display Mechanism Calibration
, click Run
, and then allow the routine to complete.NOTE: Select 'X' at top right of window to close once calibration is successful.
- Type "display mech" into the search field, click Display Mech Functional Test
, click Run
, and then allow the routine to complete.NOTE: Select 'X' at top right of window to close once calibration is successful.
- Disconnect the laptop with Toolbox 3 from the vehicle. See Toolbox 3 - Connect And Disconnect .
- Raise the RH front window.
- Close the RH front door.