LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2024 >> Model S Plaid >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Gauges & Instrument Panels >> Infotainment System -- Model S >> Displays >> Touchscreen - HW3 - Remove And Replace >> Remove

Touchscreen - HW3 - Remove And Replace: Remove

WARNING: This procedure is a DRAFT, although it has been validated. Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near high voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.
  1. Verify that the vehicle firmware version is 2023.12.100 or later. If not, update the vehicle firmware. See Firmware Update .
  2. Open the RH front door and lower the RH front window.
  3. Move RH front seat backward.
  4. Disconnect LV power. See LV Power (Disconnect and Connect) .
  5. Remove the instrument panel service panel, but do not remove the cabin temperature sensor fan from the service panel. See Service Panel - Instrument Panel (Remove And Replace) .
  6. Remove the bolts (x2) that attach the touchscreen bracket to the IP carrier.
    NOTE: 10 mm
    G15101042Courtesy of TESLA, INC.
    G15101043Courtesy of TESLA, INC.
  7. Disconnect the electrical connectors (x2) for the touchscreen tilt motors, if equipped.
    G00645764Courtesy of TESLA INC
  8. Release the tabs (x3) that attach the touchscreen shroud to the touchscreen, and then remove the shroud from the vehicle.
    NOTE: Slide the display outwards until the shroud fully clears the IP and support. Release the bottom tabs and pull upward.
    G15101044Courtesy of TESLA, INC.
    G15101045Courtesy of TESLA, INC.
  9. Release the harness clip, and then disconnect the coax and power connectors from the touchscreen.
    NOTE: Support the touchscreen and slide it rearward to access the connectors.
    G15101046Courtesy of TESLA, INC.
  10. Remove the touchscreen from the vehicle.
  11. Place the touchscreen on a soft and clean working surface.
    G15101047Courtesy of TESLA, INC.
  12. Remove the bolt that attaches the ground strap to the touchscreen.
    CAUTION: Replace the bolt if it is damaged. Failure to properly reconnect the ground strap will result in display functionality issues.
    NOTE: 4 N.m, T20
    G15101048Courtesy of TESLA, INC.
  13. Remove and discard the bolts (x2) that attach the display mechanism to the touchscreen housing.
    NOTE: 10 mm, 10 N.m
    G15101049Courtesy of TESLA, INC.
  14. Remove the display mechanism from the touchscreen housing.
    G15101050Courtesy of TESLA, INC.
    G15101051Courtesy of TESLA, INC.
scientia non olet · About LEMON Manuals