LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2024 >> Model S Base >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Exterior Fittings -- Model S >> Badges and Films >> Tesla Badge - Front - Remove And Replace >> Install

Tesla Badge - Front - Remove And Replace: Install

  1. Position the front Tesla T-badge onto the T-badge support, and then install the screws (x3).

    1.8 N.m (1.3 ft-lbs) 

    NOTE: One fastener is located under the rear lip.

    Tip: Use of the following tool(s) is recommended:

    • Torx T25 socket
    • 4 in extension
    • Torque wrench 1/4 in drive hexagon - 1060071-00-A
    G15081115Courtesy of TESLA, INC.
  2. Install the front underhood apron. See Underhood Apron - Front (Remove And Replace) .
  3. Install the LH and RH underhood aprons. See Underhood Apron - LH (Remove And Replace) .
  4. Install the rear underhood apron. See Underhood Apron - Rear (Remove And Replace) .
scientia non olet · About LEMON Manuals