T Badge Support - Fascia - Front - Remove And Replace: Install

Position the front fascia V bar on the T badge support, and then install the clips that attach the V bar to the T badge support.
NOTE: Align the V bar guides with the T badge support.

Courtesy of TESLA, INC.

Courtesy of TESLA, INC.
Install the two screws that attach the front fascia V bar to the T badge support.
Torque 3 N.m

Tip: Use of the following tool(s) is recommended:
- Torx T25 socket
- 4 in extension
- Flex head ratchet/flex head torque wrench
Courtesy of TESLA, INC.
Position the front BLE module on the T badge support, and then install the two screws that attach the module to the T badge support.
Torque 3 N.m

Tip: Use of the following tool(s) is recommended:
- Torx T25 socket
- 4 in extension
- Flex head ratchet/flex head torque wrench
Courtesy of TESLA, INC.
Install the three screws that attach the front fascia T badge to the T badge support.
Torque 3 N.m

Tip: Use of the following tool(s) is recommended:
- Torx T25 socket
- 4 in extension
- Flex head ratchet/flex head torque wrench
Courtesy of TESLA, INC.
Position the T badge support on the front fascia, and then install the clips and datums that attach the T badge support to the fascia.

Courtesy of TESLA, INC.
Install the screw that attaches the T badge support to the front fascia.
Torque 3 N.m

Tip: Use of the following tool(s) is recommended:
- Torx T25 socket
- 4 in extension
- Flex head ratchet/flex head torque wrench
Courtesy of TESLA, INC.
Connect the electrical harness to the front BLE module.
CAUTION: Push the red locking tab into the connector to engage the locking mechanism. DO NOT push down or pull up on the red locking tab.

Courtesy of TESLA, INC.
Install the front fascia assembly Fascia Assembly - Front (Remove And Install) .