Grille - Fascia - Front - Remove And Replace: Remove

Remove the front fascia assembly. See Fascia Assembly - Front (Remove And Install) .
Release clips (x6) that attach the wiring harness to the front fascia grille.
NOTE: 6x clips

Courtesy of TESLA, INC.
Disconnect the pedestrian warning speaker electrical connector, and then release the clip that attaches the warning speaker to the front fascia.
NOTE: DO NOT push down on the red locking tab. Pull the tab away from the connector until the connector is unlocked, and then continue pulling to release the connector.

Courtesy of TESLA, INC.
Remove clips (x8) that attach the valance to the front fascia assembly.

Courtesy of TESLA, INC.
Remove the nuts that attach the valance to the front fascia assembly, and then remove the valance from the assembly.
Tip: Use of the following tool(s) is recommended:
- 10 mm deep socket
- Flex head ratchet/flex head torque wrench
NOTE: Release LH and RH corners of the valance from the fascia to release it from the assembly.

Courtesy of TESLA, INC.

Courtesy of TESLA, INC.

Courtesy of TESLA, INC.
Remove the screws (x2) that attach the front fascia grille to the front fascia assembly.
Tip: Use of the following tool(s) is recommended:
- Torx T25 socket
- Flex head ratchet/flex head torque wrench
- 4 in extension
Courtesy of TESLA, INC.
Release the tabs (x11) that attach the front fascia grille to the front fascia assembly, and then remove the grille from the assembly.

Courtesy of TESLA, INC.

Courtesy of TESLA, INC.

Courtesy of TESLA, INC.

Courtesy of TESLA, INC.