Microphone - Seat - 2nd Row - RH - Remove And Replace: Remove
- Remove the RH 2nd row seat outer bolster. See Bolster - Outer - Seat - 2nd Row - LH (Remove And Replace) .
- Fold the RH 2nd row seat to the down position.NOTE: If the 2nd row lower seat cushion is not present, protect the seat as required.
- Disconnect the RH 2nd row seat back harness electrical connector.
- Release the clip that attaches the RH 2nd row seat back harness to the pivot bracket.
- Remove the RH 2nd row seat back panel. See Back Panel - 2nd Row Seat - RH (Remove And Replace) .
- Remove the RH 2nd row headrest. See Headrest - 2nd Row - LH (Remove And Replace) .
- Remove the RH 2nd row backrest LH and RH headrest guides.NOTE: Lift the headrest guide locking tabs and slide headrest guide out of frame assembly. Guide with adjustment button installed inboard.
- Remove the bolts (x2) that attach the RH 2nd row backrest cushion to the back frame.
8 N.m (5.9 ft-lbs)
Tip: Use of the following tool(s) is recommended:
- 10 mm socket
- Fold the RH 2nd row seat to the vertical position, but do not latch the seat back.
- Release the clips (x8) that attach the RH 2nd row backrest cushion to the backrest frame, and then disconnect the electrical connector to remove the backrest cushion from the assembly.
- Disconnect the RH 2nd row seat back substrate harness electrical connectors (x2).
- Release the hooks (x2) that attach the bottom portion of RH 2nd row seat backrest trim to the RH 2nd row seat back substrate.NOTE: Maneuver the trim under the harness.
- Release the clips (x2) that attach the RH 2nd row backrest cushion heat pad harness to the RH 2nd row seat back substrate.
- Release the clips (x5) that attach the RH 2nd row seat back trim to the RH 2nd row seat back substrate.NOTE: Maneuver the clips around the substrate harness.
- Release the hooks (x6) and clips (x2) that attach the top portion of RH 2nd row seat back trim to the RH 2nd row seat back substrate.
- Pull top the portion of RH 2nd row seat back trim down and off of the RH 2nd row seat back substrate.
- Remove the RH 2nd row seat back substrate assembly from the cushion assembly.NOTE: Maneuver heat pad harness under substrate harness.
- Release the clip that attaches the RH 2nd row microphone harness to the RH 2nd row seat back substrate.
- Release the clips (x3) and tabs (x2) that attach the RH 2nd row microphone assembly to the RH 2nd row seat back substrate.