Bracket - A-Pillar - Upper - LH - Remove And Replace: Install
- Install the bolts (x4) that attach the LH upper A-pillar trim bracket to the vehicle.
4 N.m (2.9 ft-lbs)
Tip: Use of the following tool(s) is recommended:
- 10 mm socket
- 2 in extension
- Ratchet/torque wrench
- Position the electrical harness to the LH upper A-pillar trim bracket.
- Install the LH upper A-pillar trim. See Trim - A-Pillar - Upper - LH (Remove And Replace) .
- Install the LH instrument panel end cap. See End Cap - Instrument Panel - LH (Remove and Replace) .
- Install the LH middle A-pillar trim. See Trim - A-Pillar - Middle - LH (Remove And Replace) .
- Raise the LH front window and close the LH front door.