Reflex Marker - Taillight - RH (Global) - Remove And Replace: Install

Install the reflex marker to the vehicle.
NOTE: Press gently to ensure the datums (x2) are fully seated into the grommets.

Courtesy of TESLA, INC.

Courtesy of TESLA, INC.
Install the nut that attaches the reflex marker to the body.
1 Nm (0.7 lbs-ft)

Tip: Use of the following tool(s) is recommended:
- Flex head ratchet/flex head torque wrench
- 8 mm 12-point deep socket
- Ratchet/torque wrench
Courtesy of TESLA, INC.
Install the RH trunk side trim. See Trim - Side - Trunk - RH - Remove And Replace .
Install the rear wall trim. See Trim - Rear Trunk - Rear Wall - Remove And Replace .
Install the trunk floor front trim. See Trim - Front - Floor - Trunk - Remove And Replace .
Install the RH trunk load floor bracket. See Bracket - Trunk Load Floor - RH - Remove And Replace .
Install the trunk sill panel. See Trim - Sill - Trunk - Remove And Replace .
Install the trunk load floor. See Trunk Load Floor - Rear - Remove And Replace .
Install the parcel shelf. See Parcel Shelf - Rear Trunk - Remove And Replace .