Wheel Speed Sensors - Rear Wheel Speed Sensor - Remove And Replace: Remove
- Remove the LH rear wheel. See WHEEL ASSEMBLY - REMOVE AND INSTALL .
- Release the clip that attaches the rear ABS wheel speed sensor connector to the subframe, and then disconnect the subframe harness from the connector.
Tip: Use a mechanical pickup tool to hold the connector in place, and then release the connector clip with a screwdriver.
- Release the clip that attaches the LH rear ABS wheel speed sensor cable to the subframe.
- Remove the bolt that attaches the LH rear ABS wheel speed sensor to the knuckle.
Tip: Use of the following tool(s) is recommended:
- 10 mm socket
- Flex head ratchet/flex head torque wrench
- 4 in extension
- Remove the grommet that attaches the LH rear ABS wheel speed sensor cable to the knuckle, and then remove the sensor from the vehicle.