Rear Brake Rotors - Calipers and Pads - Rear Brake Caliper Sport - LH - Remove And Replace: Install

Install the LH rear brake caliper onto the LH rear knuckle, and then install new bolts to attach the caliper to the knuckle.
83 N.m (61.2 lbs-ft)

Tip: Use of the following tool(s) is recommended:
- Cordless Ratchet/Impact Driver
- 3 in extension
- External Torx E18
- Ratchet/torque wrench
Courtesy of TESLA, INC.
Install the bolt that attaches a new hose to the LH rear brake caliper.
42 N.m (31.0 lbs-ft)

NOTE: The bolt and washers are captive in the new hose assembly.

Tip: Use of the following tool(s) is recommended:
- Ratchet/torque wrench
- 11 mm 12-point deep socket
Courtesy of TESLA, INC.
Install the hose into the jounce hose bracket, and then install a new clip that attaches the brake hose to the jounce hose bracket.
NOTE: Pay attention to the clip orientation.

Courtesy of TESLA, INC.
Install the brake line tube nut to the brake hose at the jounce hose bracket.
16 N.m (11.8 lbs-ft)

Tip: Use of the following tool(s) is recommended:
- 3 in extension
- Ratchet/torque wrench
- 12 mm socket
Courtesy of TESLA, INC.
Install the bolt that attaches the LH rear EPB harness bracket to the LH rear caliper.
5 N.m (3.7 lbs-ft)

Tip: Use of the following tool(s) is recommended:
- 4 in extension
- Ratchet/torque wrench
- 10 mm socket
Courtesy of TESLA, INC.
Connect the LH rear EPB caliper connector.

Courtesy of TESLA, INC.
Remove the oil drain from under the vehicle.
Perform a brake fluid flush on the LH rear brake. See BRAKE FLUID BLEED/FLUSH (MAINTENANCE) .