LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2024 >> Model 3 Performance >> Repair and Diagnosis (Single Page) >> Body & Frame >> Seats -- Model 3 >> Front Seat Covers Pads and Trims >> Front Seat Covers And Pads - 1st Row Seat Cushion Foam - Remove And Replace >> Install

Front Seat Covers And Pads - 1st Row Seat Cushion Foam - Remove And Replace: Install

  1. Route the connector of the new occupancy sensor through the notch, and then stick the new sensor onto the new seat cushion foam.
    G16589182Courtesy of TESLA, INC.
    G16589183Courtesy of TESLA, INC.
  2. Install the seat cushion heating wire onto the cushion foam.
    G16589184Courtesy of TESLA, INC.
  3. Install the driver seat cushion foam.
  4. Install the driver seat cushion cover. See FRONT SEAT COVERS AND PADS - 1ST ROW SEAT CUSHION TRIM ASSEMBLY - LH DRIVE, LH - REMOVE AND REPLACE .
scientia non olet · About LEMON Manuals