- Starting from the RH 2nd row headrest, install the RH 2nd row seat back upholstery cover.
NOTE:
Massage the Velcro while working downward toward the center of the seat back.
 Courtesy of TESLA, INC.
|
- Use hog ring pliers to crimp new hog rings (1566544-00-A) (x3) to the RH 2nd row seat back upholstery trim cover at the center of the seat back.
NOTE:
Place the hog ring into the hog ring pliers prior to installation.
NOTE:
Push down on the foam to allow access to the rings.
 Courtesy of TESLA, INC.
|
 Courtesy of TESLA, INC.
|
- Attach the remaining portion of the RH 2nd row seat back upholstery cover to the seat back.
NOTE:
Massage the Velcro while working downward toward the bottom of the seat back.
 Courtesy of TESLA, INC.
|
- Install the lower portion of the RH seat back upholstery cover to the pivot bar.
 Courtesy of TESLA, INC.
|
- Put the electrical harness through the RH seat back upholstery cover.
 Courtesy of TESLA, INC.
|
- Zip the RH 2nd row seat back cover.
 Courtesy of TESLA, INC.
|
- Install the RH 2nd row seat back latch release bezel. See 2ND ROW SEAT BACK HARDWARE - 2ND ROW SEATBACK LATCH RELEASE BEZEL - RH - REMOVE AND REPLACE .
- Install the RH 2nd row escutcheon. See 2ND ROW SEAT BACK HARDWARE - 2ND ROW SEATBACK CENTER ESCUTCHEON - REMOVE AND REPLACE .
NOTE:
There are 2 clips in the RH 2nd row escutcheon.
- Install the RH 2nd row seat back hinge bracket. See 2ND ROW SEAT BACK HARDWARE - 2ND ROW SEATBACK HINGE BRACKET ASSEMBLY - LH - REMOVE AND REPLACE .
- Install the RH 2nd row seat back. See 2ND ROW SEAT ASSEMBLIES - 2ND ROW SEATBACK - RH - REMOVE AND REPLACE .
- Install the 2nd row lower seat cushion. See 2ND ROW SEAT ASSEMBLIES - 2ND ROW SEAT CUSHION - REMOVE AND REPLACE .
- Install the RH 2nd row seat side bolster. See 2ND ROW SEAT ASSEMBLIES - 2ND ROW BOLSTER - LH - REMOVE AND REPLACE .