Front Energy Absorber - Bumper Beam Foam - Remove And Replace: Install

Install the front bumper beam foam onto the front bumper beam.
Position the protection pressure tube sensor assembly to the front bumper beam foam, and then install new clips (x2) that attach the LH and RH pedestrian protection pressure tube sensors.

Courtesy of TESLA, INC.
Install the clips (x4) that attach the front bumper beam foam to the front bumper beam.

Courtesy of TESLA, INC.
Connect the LH and RH pedestrian protection pressure tube sensors.
NOTE: LH

Courtesy of TESLA, INC.

NOTE: RH

Courtesy of TESLA, INC.
Install the front fascia assembly. See FRONT BUMPER FASCIA - FASCIA ASSEMBLY - FRONT - REMOVE AND REPLACE .