Front Energy Absorber - Assembly Crush Can LH - Remove And Replace: Remove

Remove the front fascia. See FRONT BUMPER FASCIA - FASCIA ASSEMBLY - FRONT - REMOVE AND REPLACE .
Remove the cooling fan module. See FAN AND RADIATOR - COOLING FAN MODULE - REMOVE AND REPLACE .
Lower the vehicle.
Use a clip prytool to release the clips (x3) that attach the harness to the LH front crush can.

Courtesy of TESLA, INC.
Remove the bolt that attaches the LH front fender support to the LH front crush can.
35 N.m (25.8 lbs-ft)

Tip: Use of the following tool(s) is recommended:
- Ratchet/torque wrench
- Cordless Ratchet/Impact Driver
- 10 mm hex socket
Courtesy of TESLA, INC.
Remove the bolts (x4) that attach the LH front crush can to the LH front inner rail.
90 N.m (66.4 lbs-ft)

Tip: Use of the following tool(s) is recommended:
- Breaker bar
- 18 mm socket
- Cordless Ratchet/Impact Driver
Courtesy of TESLA, INC.
Remove the LH front crush can from the LH front inner rail.

Courtesy of TESLA, INC.