Front Energy Absorber - Assembly Crush Can LH - Remove And Replace: Install

Install the LH front crush can into the LH front inner rail.
NOTE: Lightly tap the crush can with a dead blow harmer to assist with installation into the inner rail.
Install the bolts (x4) that attach the LH front crush can to the LH front inner rail.
90 N.m (66.4 lbs-ft)

Tip: Use of the following tool(s) is recommended:
- 18 mm socket
- Cordless Ratchet/Impact Driver
- Ratchet/torque wrench
Courtesy of TESLA, INC.
Install the bolt that attaches the LH front fender support to the LH front crush can.
35 N.m (25.8 lbs-ft)

Tip: Use of the following tool(s) is recommended:
- Cordless Ratchet/Impact Driver
- 10 mm hex socket
- Flex head ratchet/flex head torque wrench
Courtesy of TESLA, INC.
Install the clips (x3) that attach the harness to the LH front crush can.

Courtesy of TESLA, INC.
Install the cooling fan module. See FAN AND RADIATOR - COOLING FAN MODULE - REMOVE AND REPLACE .
Install the front fascia. See FRONT BUMPER FASCIA - FASCIA ASSEMBLY - FRONT - REMOVE AND REPLACE .