Closure Panels - Assembly - Rear Door - Left - Remove And Install: Remove
- Open the rear LH door, and fully lower the window.
- Release the clips (x4) of the rear LH door electrical harness seal at the B-pillar, and pull the wiring harness out of the B-pillar bulkhead.
- Disconnect the LH rear door harness connector from the LH body harness.
- Remove the bolt that attaches the LH rear door check strap to the body.NOTE: Unbolting the door check allows the door to swing freely beyond opening limits.
Tip: Use of the following tool(s) is recommended:
- Cordless Ratchet/Impact Driver
- 4 in extension
- Torx T40 socket
- Ratchet/torque wrench
- With assistance, remove the bolts (x4) that attach the LH rear door assembly to the vehicle.
Tip: Use of the following tool(s) is recommended:
- 10 mm socket
- Ratchet/torque wrench