Hood Hinges And Fittings - Active Hood Hinge, LH - Remove And Replace: Install

Position the LH hood hinge into the vehicle.
Install the bolts (x2) that attach the LH hood hinge to the body.
24 N.m (17.7 lbs-ft)

NOTE: Use the masking tape to aid in alignment. Adjust the hood hinge as needed.
NOTE:
Use of the following tool(s) is recommended:
- 13 mm socket
- Ratchet/torque wrench
WARNING: The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.

multimedia:A supplement to the article is available.

Courtesy of TESLA, INC.
Remove the masking tape from the LH hinge location.
With an assistant, install the hood. See HOOD ASSEMBLY - REMOVE AND REPLACE .
Install the wiper motor. See ELECTRICAL - WIPERS AND WASHER - WINDSHIELD WIPERS AND MOTOR - WIPER MODULE - REMOVE AND REPLACE .
Install the cowl screen panel. See UNDERHOOD TRIM - ASSEMBLY, COWL SCREEN, LHD - REMOVE AND REPLACE .
Install the LH and RH shock tower covers. See UNDERHOOD TRIM - SHOCK TOWER COVER LH - REMOVE AND INSTALL .
Install the LH and RH hood hinge covers. See HOOD HINGES AND FITTINGS - HOOD HINGE COVER LH - REMOVE AND REPLACE
Install the LH and RH wiper arms and blades. See ELECTRICAL - WIPERS AND WASHERS - WINDSHIELD WIPERS AND MOTOR - WIPER ARM DR - REMOVE AND REPLACE .
Install the underhood storage unit. See EXTERIOR FITTINGS - LUGGAGE COMPARTMENT TRIM - FRONT LUGGAGE STORAGE COMPARTMENT - FRUNK ASSEMBLY - REMOVE AND REPLACE .
Install the access panel. See FRONT BUMPER FASCIA - ASSEMBLY, ACCESS PANEL - REMOVE AND REPLACE .
Install the cabin intake duct. See CABIN HVAC - HVAC, FRESH AIR GUTTER, ASSEMBLY - REMOVE AND REPLACE .
Install the rear underhood apron. See UNDERHOOD TRIM - REAR APRON ASSEMBLY - REMOVE AND REPLACE .