Tail Lights - Lamp Assembly, Decklid, LH - Remove And Replace: Remove
- Open the LH front door and lower the LH front window.
- Remove the trunk lid trim. See TRUNK INTERIOR - LOWER LIFTGATE, ASSEMBLY - REMOVE AND REPLACE .
- Release the connector lock, and then disconnect the electrical harness from the taillight connector.CAUTION: DO NOT push down on the red locking tab. Pull the tab away from the connector until the connector is unlocked, and then continue pulling to release the connector.CAUTION: If the taillight must be replaced because of water ingress, place a shop towel under the taillight connector to prevent damage to other electrical components.
- Remove the nut and the bolts (x2) that attach the taillight to the body.
Tip: Use of the following tool(s) is recommended:
- 8 mm deep socket
- Ratchet/torque wrench
WARNING: The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.multimedia:A supplement to the article is available.NOTE: Apply strong pressure to stud with right hand to remove the headlamp evenly. - Release the stud and clips (x2) that attach the LH taillight to the body, and then remove the LH taillight assembly from the vehicle.NOTE: Do not only pull the lamp from left side, remove both sides evenly.