- Tape the LH and RH backlight glass antenna connectors to the backlight glass.
 Courtesy of TESLA, INC.
|
- Starting from one of the corners, remove a part of the backing tape from the new upper perimeter seal, and then slowly apply the backing to the old adhesive path on the backlight glass.
NOTE:
Work your way around until the whole seal is installed.
NOTE:
Firmly press the seal onto the backlight glass.
NOTE:
Ensure that the adhesive backing is installed as close to the edge of the backlight glass as possible.
 Courtesy of TESLA, INC.
|
 Courtesy of TESLA, INC.
|
- Starting by installing the trunk flip seal where the upper perimeter seal ends, remove a part of the backing tape from the new trunk flip seal, and then slowly apply the backing to the old adhesive path on the backlight glass.
NOTE:
Work your way around until the whole seal is installed.
NOTE:
Firmly press the seal onto the backlight glass.
NOTE:
Ensure that the adhesive backing is installed as close to the edge of the backlight glass as possible.
 Courtesy of TESLA, INC.
|
- Cut off any overlap length of the trunk flip seal to match the upper perimeter seal.
 Courtesy of TESLA, INC.
|
- Use the teflon tape rectangles to install the new net pads to the four sides of the backlight glass.
NOTE:
Cut teflon tape into rectangles having dimensions 5 mm x 20 mm.
NOTE:
The net pads' number may vary as needed.
 Courtesy of TESLA, INC.
|
 Courtesy of TESLA, INC.
|
 Courtesy of TESLA, INC.
|
- Install the backlight glass. See WINDSHIELD AND TRUNK GLASS - BACKLITE - REMOVE AND REPLACE .