Electrical - Wipers and Washers - Windshield Washer Bottle and Pump - Washer Level Sensor - Remove And Replace: Remove

Remove the underhood storage unit. See EXTERIOR FITTINGS - LUGGAGE COMPARTMENT TRIM - FRONT LUGGAGE STORAGE COMPARTMENT - FRUNK ASSEMBLY - REMOVE AND REPLACE .
Open the washer reservoir cap.
Place a fluid evacuator near the front of the vehicle and connect it with a compressed air.
Open the evacuator valve and position the evacuator hose into a corner of the washer reservoir, and then evacuate as much as washer as possible.
Disconnect the compressed air and remove the fluid evacuator.
Disconnect the windshield washer level sensor connector.

Courtesy of TESLA, INC.
Use a plastic trim tool to gently pry the washer level sensor from the washer reservoir.
CAUTION: Be careful not to damage the sensor.

Courtesy of TESLA, INC.

Courtesy of TESLA, INC.
Remove the grommet from the washer level sensor, inspect for damage and replace if necessary.

Courtesy of TESLA, INC.

Courtesy of TESLA, INC.