Dash Support Frame - IP Riser Bracket, RH - Remove And Replace: Install
- Install the RH cross bar beam to the vehicle.
- Install the bolt that attaches the RH cross bar beam bracket to the cross beam.
25 N.m (18.4 lbs-ft)
Tip: Use of the following tool(s) is recommended:
- Cordless Ratchet/Impact Driver
- 13 mm socket
- Flex head ratchet/flex head torque wrench
- Install the nut that attaches the RH cross bar beam bracket to the cross beam.
Tip: Use of the following tool(s) is recommended:
- 13 mm socket
- Cordless Ratchet/Impact Driver
- Flex head ratchet/flex head torque wrench
- Install the RH center console front side panel. See CENTER CONSOLE - CONSOLE SIDE PANEL, CARPET, RH, LHD - REMOVE AND REPLACE .