LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2024 >> Model 3 Performance >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Exterior Lights >> Electrical System (2 Of 2) -- Model 3 >> Wipers and Washers >> RHD Electrical - Wipers and Washer - Windshield Wipers and Motor - Wiper Module - Remove And Replace >> Install

RHD Electrical - Wipers and Washer - Windshield Wipers and Motor - Wiper Module - Remove And Replace: Install

  1. Connect the wiper module connector.
    NOTE: Do not place the limbs within the linkage movement area as the wiper arms will automatically transition to parking mode.
    G16596513Courtesy of TESLA, INC.
  2. Install the bolts (x3) that attach the wiper module to the body.

    7 N.m (5.2 lbs-ft) 

    Tip: Use of the following tool(s) is recommended:

    • 2 in extension
    • Cordless Ratchet/Impact Driver
    • 10 mm socket
    • Ratchet/torque wrench
    G16596514Courtesy of TESLA, INC.
  3. Install the cowl screen panel. See Underhood Trim - Assembly, Cowl Screen, LHD - Remove And Replace .
  4. Install the wiper arms. See ELECTRICAL - WIPERS AND WASHERS - WINDSHIELD WIPERS AND MOTOR - WIPER ARM DR - REMOVE AND REPLACE .
  5. Install the fresh air gutter assembly. See CABIN HVAC - HVAC, FRESH AIR GUTTER, ASSEMBLY - REMOVE AND REPLACE .
  6. Install the rear underhood apron. See UNDERHOOD TRIM - REAR APRON ASSEMBLY - REMOVE AND REPLACE .
  7. Raise the RH front window and close the RH front door.