Electrical - Liftgate Camera - AP4 Back Up Camera, Liftgate Handle - Remove And Replace: Install

Install the screws (x2) that attach the rear facing camera to the trunk exterior release switch.
Tip: Use of the following tool(s) is recommended:
- Digital Torque Screwdriver 0.10 N.m - 2.0 N.m
- Phillips Screwdriver
Install the trunk exterior release switch. See TRUNK HANDLE AND EMERGENCY RELEASE - LIFTGATE HANDLE ASSEMBLY - REMOVE AND REPLACE .
Install the trunk lid trim. See TRUNK INTERIOR - LOWER LIFTGATE, ASSEMBLY - REMOVE AND REPLACE .
Connect a laptop with Toolbox 3 to the vehicle.
In Toolbox, select the connection status icon at the top right corner, and then select "Connect Locally".
NOTE: The icon will turn green when the vehicle is connected.
Unlock the vehicle gateway. See GATEWAY UNLOCK .
Touch Vehicle Info > Driver Assist > Cameras > Reset DAS on the touchscreen, follow the onscreen instructions and run the routine.
In Toolbox, click the Actions/Autodiag tab, type "Calibration Mode" into the search field, click DAS Enter Calibration Mode , click Run , and allow the routine to complete.
Click the Actions tab, type "back up" into the search field, click PING-HTTP_DAS_X_BACKUP-CAMERA-SCRIPT , click Run , and allow the routine to complete.
Verify that the rear facing camera works properly.
Disconnect the laptop from the vehicle.