Infotainment - Audio System - Speakers, Subwoofer and Amplifier - Audio Speakers - External Audio Amplifier - Remove And Replace: Install
- Insert the tabs (x2) of the amplifier into the slots and then install the bolt that attaches the audio amplifier to the body.
6 N.m (4.4 lbs-ft)
Tip: Use of the following tool(s) is recommended:
- Cordless Ratchet/Impact Driver
- 10 mm socket
- 4 in extension
- Ratchet/torque wrench
- Connect the connectors (x3) to the RH rear audio amplifier.
- Return the RH trunk side trim carpet back to its original position.
- Install the clip that attaches the RH trunk side trim to the body.
- Install the trunk garnish. See TRUNK INTERIOR - TRUNK GARNISH, ASSEMBLY - REMOVE AND REPLACE .
- Install the RH load floor bracket. See TRUNK CARPET AND SIDE FINISHERS - LOAD FLOOR BRACKET LH - REMOVE AND REPLACE .
- Install the trunk sill trim. See A-B-C POST INTERIOR TRIM - TRUNK SILL - REMOVE AND REPLACE .
- Connect the LV battery power. See LV BATTERY - LI-LON - DISCONNECT AND CONNECT .
- Install the rear underhood apron. See UNDERHOOD TRIM - REAR APRON ASSEMBLY - REMOVE AND REPLACE .
- Install the trunk load floor. See TRUNK CARPET AND SIDE FINISHERS - LOAD FLOOR ASSEMBLY - REMOVE AND REPLACE .