Infotainment - Audio System - Speakers, Subwoofer and Amplifier - Audio Speakers - Audio Speaker Full Range, LH - Remove And Replace: Install
- Connect the electrical connector to the LH dash speaker connector.
- Install the screws (x3) that attach the LH dash speaker to the instrument panel.
2.3 N.m (1.7 lbs-ft)
Tip: Use of the following tool(s) is recommended:
- Torx T20 bit
- Ratchet/torque wrench
- Install the instrument panel speaker grille. See INSTRUMENT PANEL - INSTRUMENT PANEL - DASH PANEL - IP WRAPPED AROUND ASSEMBLY - REMOVE AND REPLACE
.NOTE: No need to run the TEST-SELF_VCLEFT_RGB(i) via Toolbox.
- Install the LH and RH upper A-Pillar trims. See A - B - C POST INTERIOR TRIM - A - PILLAR UPPER ASSEMBLY, LH - REMOVE AND REPLACE .
- Install the LH and RH instrument panel end caps. See DASH PANEL - END CAP, LH - REMOVE AND REPLACE .