Exterior Fittings - Luggage Compartment Trim - Front Luggage Storage Compartment - Frunk Reinforcement Assembly - Remove And Replace: Install

Install the bolts (x4) to attach the cooling fan module isolation brackets to the new frunk reinforcement assembly.
6 N.m (4.4 lbs-ft)

Tip: Use of the following tool(s) is recommended:
- Cordless Ratchet/Impact Driver
- 10 mm 12-point deep socket
- Ratchet/torque wrench
Courtesy of TESLA, INC.

Courtesy of TESLA, INC.
Place the frunk reinforcement bracket onto the fan assembly, and then install the bolts (x2) that attach the frunk reinforcement bracket to the fan assembly.
16 N.m (11.8 lbs-ft)

Tip: Use of the following tool(s) is recommended:
- Cordless Ratchet/Impact Driver
- 2 in extension
- 10 mm socket
Courtesy of TESLA, INC.

Courtesy of TESLA, INC.
Install the harness clips (x3) to the frunk reinforcement bracket.

Courtesy of TESLA, INC.
Install the underhood storage unit. See EXTERIOR FITTINGS - LUGGAGE COMPARTMENT TRIM - FRONT LUGGAGE STORAGE COMPARTMENT - FRUNK ASSEMBLY - REMOVE AND REPLACE .