LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2024 >> Model 3 Long Range >> Repair and Diagnosis (Single Page) >> Body & Frame >> Seats -- Model 3 >> 2nd Row Seat Covers Pads and Trims >> 2nd Row Seat Covers And Pads - 2nd Row Seat Back Trim, RH - Remove And Replace >> Remove

2nd Row Seat Covers And Pads - 2nd Row Seat Back Trim, RH - Remove And Replace: Remove

  1. Remove the RH 2nd row seat side bolster. See 2ND ROW SEAT ASSEMBLIES - 2ND ROW BOLSTER - LH - REMOVE AND REPLACE .
  2. Remove the 2nd row lower seat cushion. See 2ND ROW SEAT ASSEMBLIES - 2ND ROW SEAT CUSHION - REMOVE AND REPLACE .
  3. Remove the RH 2nd row seat back. See 2ND ROW SEAT ASSEMBLIES - 2ND ROW SEATBACK - RH - REMOVE AND REPLACE .
  4. Remove the RH 2nd row seat back hinge bracket. See 2ND ROW SEAT BACK HARDWARE - 2ND ROW SEATBACK HINGE BRACKET ASSEMBLY - LH - REMOVE AND REPLACE .
  5. Remove the RH 2nd row escutcheon. See 2ND ROW SEAT BACK HARDWARE - 2ND ROW SEATBACK CENTER ESCUTCHEON - REMOVE AND REPLACE .
    NOTE: There are 2 clips in the RH 2nd row escutcheon.
  6. Remove the RH 2nd row seat back latch release bezel. See 2ND ROW SEAT BACK HARDWARE - 2ND ROW SEATBACK LATCH RELEASE BEZEL - RH - REMOVE AND REPLACE .
  7. Unzip the RH 2nd row seat back upholstery cover.
    G16589320Courtesy of TESLA, INC.
  8. Put the electrical harness through the RH 2nd row seat back upholstery cover.
    G16589321Courtesy of TESLA, INC.
  9. Release the lower portion of the RH 2nd row seat back upholstery cover from the pivot bar.
    G16589322Courtesy of TESLA, INC.
  10. Gently separate the RH seat back upholstery cover from the foam starting from the bottom of the cover.
    NOTE: Make sure the Velcro does not damage the foam pad.
    WARNING: The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.
    multimedia:A supplement to the article is available.
    G16589324Courtesy of TESLA, INC.
  11. Use diagonal cutters to cut the hog rings (x3) at the center of the seat back, and then release the cover from the hog rings.
    NOTE: Push down on the foam to allow access to the rings.
    NOTE: Remove any excess hog ring pieces.
    G16589325Courtesy of TESLA, INC.
  12. Gently release the remaining Velcro that attach the RH 2nd row seat back upholstery cover to the foam pad.
    NOTE: Make sure the Velcro does not damage the foam pad.
    G16589326Courtesy of TESLA, INC.
  13. Remove the RH 2nd row cover from the foam pad.
    NOTE: Carefully clear seat release bezel.
    G16589327Courtesy of TESLA, INC.
    G16589328Courtesy of TESLA, INC.
scientia non olet · About LEMON Manuals