LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2024 >> Model 3 Long Range >> Repair and Diagnosis (Single Page) >> Body & Frame >> Mirrors >> Exterior Fittings -- Model 3 >> Underhood Trim >> Underhood Trim - Assembly, Cowl Screen, LHD - Remove And Replace >> Remove

Underhood Trim - Assembly, Cowl Screen, LHD - Remove And Replace: Remove

  1. Open the LH front door and lower the LH front window.
  2. Remove the rear underhood apron. See UNDERHOOD TRIM - REAR APRON ASSEMBLY - REMOVE AND REPLACE .
  3. Remove the cabin intake duct. See CABIN HVAC - HVAC, FRESH AIR GUTTER, ASSEMBLY - REMOVE AND REPLACE .
  4. Remove the LH and RH wiper arms and blades. See ELECTRICAL - WIPERS AND WASHERS - WINDSHIELD WIPERS AND MOTOR - WIPER ARM DR - REMOVE AND REPLACE .
  5. Release the clips (x4) on the LH and RH shock tower covers, and partially tuck both tower covers inside.
    NOTE: LH shown, RH similar
    G16588555Courtesy of TESLA, INC.
    G16588556Courtesy of TESLA, INC.
  6. Remove the LH and RH hood hinge covers. See HOOD HINGES AND FITTINGS - HOOD HINGE COVER LH - REMOVE AND REPLACE
  7. Disconnect the main washer hose.
    G16588557Courtesy of TESLA, INC.
  8. Release the clip that attaches the harness to the cowl screen panel.
    G16588558Courtesy of TESLA, INC.
  9. Release the clip that attaches the washer hose to the cowl screen panel.
    G16588559Courtesy of TESLA, INC.
  10. Release the clips (x4) and push clips (x2) that attach the cowl screen panel to the vehicle, and then remove the cowl screen panel from the vehicle.
    G16588560Courtesy of TESLA, INC.
    G16588561Courtesy of TESLA, INC.
    G16588562Courtesy of TESLA, INC.
    G16588563Courtesy of TESLA, INC.
scientia non olet · About LEMON Manuals