LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2024 >> Model 3 Long Range >> Repair and Diagnosis (Single Page) >> Body & Frame >> Mirrors >> Exterior Fittings -- Model 3 >> Badges and Films >> Badges - Front Sill Plate, LH - Remove And Replace >> Remove

Badges - Front Sill Plate, LH - Remove And Replace: Remove

  1. Open the LH front door and lower the LH front window.
  2. Use IPA wipes to clean around the sill plate.
  3. Apply masking tape around the perimeter of the sill plate to mark the installation positioning.
    NOTE: Place the tape as closely around the sill plate as possible.
    G16588362Courtesy of TESLA, INC.
  4. Use a plastic trim tool to carefully pry up and bend the sill plate. Pull out the door sill plate when all adhesive is separated.
    CAUTION: Be careful not to damage the vehicle trim or body.
    WARNING: The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.
    multimedia:A supplement to the article is available.
    G16588364Courtesy of TESLA, INC.
    G16588365Courtesy of TESLA, INC.
    G16588366Courtesy of TESLA, INC.
  5. Use IPA wipes to clean off any remaining adhesive.
scientia non olet · About LEMON Manuals