- Guide the seatbelt retainer through the LH upper B-pillar trim.
NOTE:
Make sure the seat belt is not twisted.
- Lower the LH front seatbelt slider and LH height adjuster to their lowest positions to align the LH front upper B-pillar trim with the B-pillar.
WARNING:
The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.
- Align the locating pins (x3) to the slots, and then install the clips that attach the LH upper B-pillar trim to the vehicle.
NOTE:
Make sure that the door seal corretly overlaps the LH upper B-pillar trim.
 Courtesy of TESLA, INC.
|
- Install the LH middle B-pillar trim. See TRIM - B-PILLAR - MIDDLE - LH - REMOVE AND REPLACE .
- Install the LH lower B-pillar trim. See A - B - C POST INTERIOR TRIM - B - PILLAR LOWER ASSEMBLY, LH - REMOVE AND REPLACE .
- Install the LH lower A-pillar trim. See A - B - C POST INTERIOR TRIM - A - PILLAR LOWER ASSEMBLY, LH - REMOVE AND REPLACE .
- Install the LH instrument panel end cap. See DASH PANEL - END CAP, LH - REMOVE AND REPLACE
.
- Install the 2nd row lower seat cushion. See 2ND ROW SEAT ASSEMBLIES - 2ND ROW SEAT CUSHION - REMOVE AND REPLACE
.
- Install the 2nd row seat side bolster. See 2ND ROW SEAT ASSEMBLIES - 2ND ROW BOLSTER - LH - REMOVE AND REPLACE
.
- Install the LH front seatbelt pretensioner coupling onto the LH front seat pretensioner.
NOTE:
Perform a pull-push-pull test to verify the pretensioner and coupling are fully seated.
- Raise all windows and close all doors.