RHD Instrument Panel - Instrument Panel - Dash Panel - Glovebox Assembly (RR) - Remove And Replace: Remove
- Remove the passenger footwell cover. See RHD INSTRUMENT PANEL - INSTRUMENT PANEL - DASH SUPPORT FRAME - PASSENGER FOOTWELL ASSEMBLY (RR) - REMOVE AND REPLACE .
- Remove the LH instrument panel end cap. See DASH PANEL - END CAP, LH - REMOVE AND REPLACE .
- Remove the clip that secures the passenger footwell duct.
- Release the locking tab, and then disconnect the connector that attaches the glove box USB cable to the car computer.
- Remove the screws (x4) that attach the glove box to the instrument panel carrier.
Tip: Use of the following tool(s) is recommended:
- Torx T20 socket
- 2 in extension
- Cordless Ratchet/Impact Driver
- WIHA Torque Screwdriver 0.8-5 N.m
- Mini Ratchet Bit Set - 1450424-00-A
- Release the clips (x10), the locator pins (x3), and a datum that attach the glove box to the instrument panel carrier.CAUTION: Avoid damage to the electromagnetic switch.
- Disconnect the glove box assembly electrical connectors (x2).
- Remove the glove box from the vehicle.
- Remove the bolts (x2) that attach the glove box USB cable to the glove box.
Tip: Use of the following tool(s) is recommended:
- Cordless Ratchet/Impact Driver
- 2 in extension
- Torx T20 socket
- Ratchet/torque wrench