RHD Instrument Panel - Instrument Panel - Dash Panel - Glovebox Assembly (RR) - Remove And Replace: Install

Install the bolts (x2) that attach the glove box USB cable to the glove box.
1.5 N.m (1.1 lbs-ft)

Tip: Use of the following tool(s) is recommended:
- Cordless Ratchet/Impact Driver
- 2 in extension
- Torx T20 socket
- Ratchet/torque wrench
Courtesy of TESLA, INC.
Connect the glove box assembly electrical connectors (x2).

Courtesy of TESLA, INC.
Secure the clips (x10), the locator pins (x3), and a datum that attach the glove box to the instrument panel carrier.

Courtesy of TESLA, INC.

Courtesy of TESLA, INC.
Install the screws (x4) that attach the glove box to the instrument panel carrier.
2.3 N.m (1.7 lbs-ft)

Tip: Use of the following tool(s) is recommended:
- Torx T20 socket
- 2 in extension
- Cordless Ratchet/Impact Driver
- WIHA Torque Screwdriver 0.8-5 N.m
- Mini Ratchet Bit Set - 1450424-00-A
Courtesy of TESLA, INC.

Courtesy of TESLA, INC.

Courtesy of TESLA, INC.
Connect the connector that attaches the glove box USB cable to the car computer, and engage the locking tab.

Courtesy of TESLA, INC.
Install the clip that secures the passenger footwell duct.
NOTE: Ensure that the footwell duct is installed in proper place.

Courtesy of TESLA, INC.
Install the LH instrument panel end cap. See DASH PANEL - END CAP, LH - REMOVE AND REPLACE .
Install the passenger footwell cover. See RHD INSTRUMENT PANEL - INSTRUMENT PANEL - DASH SUPPORT FRAME - PASSENGER FOOTWELL ASSEMBLY (RR) - REMOVE AND REPLACE .