- Remove the front fascia assembly. See FRONT BUMPER FASCIA - FASCIA ASSEMBLY - FRONT - REMOVE AND REPLACE .
NOTE:
It is not necessary to remove the front fascia harness, valance and grille from the front fascia assembly.
- Disconnect the LH and RH pedestrian protection pressure tube sensors.
NOTE:
LH
 Courtesy of TESLA, INC.
|
NOTE:
RH
 Courtesy of TESLA, INC.
|
- Remove and discard the clips (x4) that attach the front bumper beam foam to the front bumper beam.
WARNING:
The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.
 Courtesy of TESLA, INC.
|
- Remove and discard the clips (x2) that attach the LH and RH pedestrian protection pressure tube sensors to the front bumper beam foam, then remove the protection pressure tube sensor assembly from the front bumper beam foam.
 Courtesy of TESLA, INC.
|
 Courtesy of TESLA, INC.
|
 Courtesy of TESLA, INC.
|
 Courtesy of TESLA, INC.
|