Front Bumper Carrier - Reinforcement LH, Front Fascia - Remove And Replace: Remove
- Remove the front fascia assembly. See FRONT BUMPER FASCIA - FASCIA ASSEMBLY - FRONT - REMOVE AND REPLACE .NOTE: It is not necessary to remove the front fascia harness, valance and grille from the front fascia assembly.
- Remove the bolts (x2) that attach the fascia reinforcement to the front end of carrier.
Tip: Use of the following tool(s) is recommended:
- Ratchet/torque wrench
- 3 in extension
- 15 mm socket
- Cordless Ratchet/Impact Driver
- Release the tabs (x2) that lock the fascia reinforcement to the front end of carrier, then pull to remove the fascia reinforcement.