Front Bumper Carrier - Reinforcement LH, Front Fascia - Remove And Replace: Install

Lock the tab (x2) to install the fascia reinforcement to the front end of carrier.

Courtesy of TESLA, INC.
Install the bolts (x2) that attach the fascia reinforcement to the front end of carrier.
5 N.m (3.7 lbs-ft)

WARNING: The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.

multimedia:A supplement to the article is available.

Tip: Use of the following tool(s) is recommended:
- Ratchet/torque wrench
- 3 in extension
- 15 mm socket
- Cordless Ratchet/Impact Driver
Courtesy of TESLA, INC.
Install the front fascia assembly. See FRONT BUMPER FASCIA - FASCIA ASSEMBLY - FRONT - REMOVE AND REPLACE .