Front Door Hinges And Fittings - Front LH Door Check Strap - Remove And Replace: Install
- Reach inside the speaker bracket opening and install the check strap to the vehicle.
- Install the nuts (x2) that attach the check strap to the LH front door.
10 N.m (7.4 lbs-ft)
Tip: Use of the following tool(s) is recommended:
- 2 in extension
- 10 mm 12-point deep socket
- Ratchet/torque wrench
- Fasten the clips (x3) that attach the LH front door check strap to the LH front door.
- Install the bolt that attaches the LH front door check strap to the A-pillar.
Tip: Use of the following tool(s) is recommended:
- Flex head ratchet/flex head torque wrench
- 13 mm socket
- Ratchet/torque wrench
- Install the bolts (x4) and tabs (x4) that attach the front door speaker to the LH front door.
Tip: Use of the following tool(s) is recommended:
- Cordless Ratchet/Impact Driver
- 8 mm socket
- Ratchet/torque wrench
- Connect the electrical connector to the front door speaker.
- Fully lower the LH front door window and disconnect the window switch tool from the LH front door harness.
- Install the LH front door trim panel. See INTERIOR TRIM - DOOR TRIM - FRONT DOOR TRIM PAD - DOOR TRIM ASSEMBLY - LH - REMOVE AND REPLACE .
- Install the LH front door puddle light. See INTERIOR TRIM - DOOR TRIM - FRONT DOOR TRIM PAD - PUDDLE LAMP - REMOVE AND REPLACE .
- Install the LH front door reflector. See INTERIOR TRIM - DOOR TRIM - FRONT DOOR TRIM PAD - DOOR REFLECTOR - REMOVE AND REPLACE .
- Install the LH front door tweeter. See FRONT DOOR TRIM PAD - DOOR TRIM, TWEETER ASSEMBLY, FRONT LH - REMOVE AND REPLACE .