LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2024 >> Model 3 Long Range >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Body -- Model 3 >> Windshield and Body Glass >> Body - Windshield and Body Glass - Windshield and Trunk Glass - Temperature and Humidity Sensor - Remove And Replace >> Remove

Body - Windshield and Body Glass - Windshield and Trunk Glass - Temperature and Humidity Sensor - Remove And Replace: Remove

  1. Open the LH front door and lower the LH front window.
  2. Remove the camera lower cover. See REARVIEW MIRROR - REAR VIEW MIRROR, CAM LOWER COVER - REMOVE AND REPLACE .
  3. Remove the rear view mirror. See REARVIEW MIRROR - REAR VIEW MIRROR, ASSEMBLY - REMOVE AND REPLACE .
  4. Remove the camera upper cover. See REARVIEW MIRROR - REAR VIEW MIRROR, CAM COVER UPPER - REMOVE AND REPLACE .
    NOTE: No need to remove the interior camera in this step.
  5. Disconnect the harness connector from the humidity and temperature sensor on the windshield.
    G16587782Courtesy of TESLA, INC.
  6. Use a PH00 Phillips Screwdriver to remove the screws (x2) that attach the humidity and temperature sensor to the windshield bracket.
    NOTE: The fasteners are tiny, take care not to drop or misplace them. Ensure the correct Phillips screwdriver is used. Using other screwdrivers which are too large may round off the cross on the fastener head.
    G16587783Courtesy of TESLA, INC.
  7. Remove the humidity and temperature sensor from the windshield bracket.
    G16587784Courtesy of TESLA, INC.
scientia non olet · About LEMON Manuals