Closure Panels - Assembly - Front Door - Left - Remove And Install: Install
- With assistance, install the LH front door assembly onto the vehicle.NOTE: Align the bolts to their installation position.
- Hand-tighten the bolts (x4) that attach the hinges to the LH front door.NOTE: Align the hinge with the previously applied tape on the door.
Tip: Use of the following tool(s) is recommended:
- 10 mm 12 pt combination wrench
- Install the bolt that attaches the LH front door check strap to the vehicle.
24 N.m (17.7 lbs-ft)
Tip: Use of the following tool(s) is recommended:
- 13 mm Flex Head Ratcheting Combination Wrench
- Ratchet/torque wrench
- 13 mm socket
- Feed the harness through the door assembly into the cabin, and then install the grommet to the body.NOTE: Verify the seal if fully seated around the black clip prior to install.
- Connect the J7 LH front door connector to the LH body controller.NOTE: Fully seat the connector and then engage the lock.
- Close the LH front door and check the gap and flushness.NOTE: If the shouldered/tapered bolts are not allowing for successful adjustment, replace the selected shouldered/tapered bolts with 1063260-00-C. Adjust the LH front door, if necessary. Refer to CVIS for current specifications.
- Torque the bolts (x4) that attach the hinges to the LH front door.
Tip: Use of the following tool(s) is recommended:
- Flex head ratchet/flex head torque wrench
- 3/8 in Crowfoot Open End Set - 1079485-00-A
- Install the LH lower A-pillar assembly. See A - B - C POST INTERIOR TRIM - A - PILLAR LOWER ASSEMBLY, LH - REMOVE AND REPLACE .
- Install the LH instrument panel end cap. See DASH PANEL - END CAP, LH - REMOVE AND REPLACE .
- Install the driver footwell cover. See DASH PANEL - DRIVER FOOTWELL COVER ASSEMBLY - REMOVE AND REPLACE .
- Connect the LV battery power. See LV BATTERY - LI-LON - DISCONNECT AND CONNECT .
- Raise the LH front window and close the LH front door.