Hood Hinges And Fittings - Hood Strut Bracket RH - Remove And Replace: Install
- Install the LH active hood strut bracket to the body, and then install the bolts (x2) attach the bracket to the body.
10 N.m (7.4 lbs-ft)
NOTE: Use of the following tool(s) is recommended:- Cordless Ratchet/Impact Driver
- 10 mm deep socket
- 1/4 in hex to 1/4 in square 6 in adapter
- Ratchet/torque wrench
- Install the pyrotechnic actuator. See SAFETY AND RESTRAINT - SENSORS - IMPACT AND ACCELERATION SENSORS - AH PYROTECHNIC ACTUATOR, LH - REMOVE AND REPLACE
- Install the LH front wheel. See WHEEL ASSEMBLY - REMOVE AND INSTALL .
- Install the underhood storage unit. See EXTERIOR FITTINGS - LUGGAGE COMPARTMENT TRIM - FRONT LUGGAGE STORAGE COMPARTMENT - FRUNK ASSEMBLY - REMOVE AND REPLACE .
- Install the access panel. See FRONT BUMPER FASCIA - ASSEMBLY, ACCESS PANEL - REMOVE AND REPLACE .
- Connect the LV battery. See LV BATTERY - LI-ION - DISCONNECT AND CONNECT .
- Install the cabin intake duct. See CABIN HVAC - HVAC, FRESH AIR GUTTER, ASSEMBLY - REMOVE AND REPLACE .
- Install the rear underhood apron. See UNDERHOOD TRIM - REAR APRON ASSEMBLY - REMOVE AND REPLACE .
- Lower the vehicle. See RAISE VEHICLE - 2 STANDS .