Front Door Latch and Striker - Door Latch, Front LH, Base - Remove And Replace: Install
- Feed the latch cable through the opening, and then install the grommet.
- Install the bolts (x3) that attach the LH front door latch to the rear of the LH front door.
10 N.m (7.4 lbs-ft)
Tip: Use of the following tool(s) is recommended:
- Cordless Ratchet/Impact Driver
- 1/4 in hex to 1/4 in square 6 in adapter
- Torx T30 socket
- Ratchet/torque wrench
- Connect the electrical harness to the LH front door latch connector.
- Install the LH front door closeout panel. See FRONT DOOR HINGES AND FITTINGS - FRONT CLOSEOUT PANEL ASSEMBLY, LH - REMOVE AND REPLACE .NOTE: No need to install the LH front door pressure sensor to the LH front door closeout panel.
- Connect the LV power. See LV BATTERY - LI-ION - DISCONNECT AND CONNECT .
- Install the rear underhood apron. See UNDERHOOD TRIM - REAR APRON ASSEMBLY - REMOVE AND REPLACE .
- Fully lower the LH front door window and disconnect the window switch tool from the LH front door harness.
- Install the LH front door puddle light. See INTERIOR TRIM - DOOR TRIM - FRONT DOOR TRIM PAD - PUDDLE LAMP - REMOVE AND REPLACE .
- Install the LH front door trim panel. See INTERIOR TRIM - DOOR TRIM - FRONT DOOR TRIM PAD - DOOR TRIM ASSEMBLY - LH - REMOVE AND REPLACE .
- Install the LH front door reflector. See INTERIOR TRIM - DOOR TRIM - FRONT DOOR TRIM PAD - DOOR REFLECTOR - REMOVE AND REPLACE .
- Install the LH front door tweeter. See FRONT DOOR TRIM PAD - DOOR TRIM, TWEETER ASSEMBLY, FRONT LH - REMOVE AND REPLACE .