LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2024 >> Model 3 Long Range >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Window Motors & Regulators >> Doors, Windows And Latches -- Model 3 >> Trunk >> Trunk Latch - Trunk Striker - Remove And Replace >> Install

Trunk Latch - Trunk Striker - Remove And Replace: Install

  1. Align the trunk striker with the masking tape on the body, and then hand-tighten the bolts that attach the trunk striker to the body.
  2. Close the trunk and check gap/flush.
  3. Open the trunk and adjust the striker position as necessary.
  4. Repeat step  2 + and step  3 + until alignment is satisfactory.
  5. Fully tighten the bolts that attach the trunk striker to the vehicle.

    24 N.m (17.7 lbs-ft) 

    NOTE: Use of the following tool(s) is recommended:
    • Ratchet/torque wrench
    • Torx T45 socket
  6. Remove the masking tape and install the rear trunk sill trim. See A-B-C POST INTERIOR TRIM - TRUNK SILL - REMOVE AND REPLACE .
scientia non olet · About LEMON Manuals