2nd Row Seat Back Hardware - 2nd Row Trim - Black Armrest Close Out Assembly - Remove And Replace: Remove
- Remove the 2nd row LH seat side bolster. See 2ND ROW SEAT ASSEMBLIES - 2ND ROW BOLSTER - LH - REMOVE AND REPLACE .
- Remove the 2nd row lower seat cushion. See 2ND ROW SEAT ASSEMBLIES - 2ND ROW SEAT CUSHION - REMOVE AND REPLACE .
- Remove the 2nd row LH seat back. See 2ND ROW SEAT ASSEMBLIES - 2ND ROW SEATBACK - LH - REMOVE AND REPLACE .
- Turn over the 2nd row LH seat back assembly and then unzip the seat back trim cover.
- Pull the clip strips of the seat back trim cover away from the seat frame to release the clip strips and then lift the seat back trim cover to uncover the frame.
- Unfold the center armrest from the 2nd row LH seat back assembly.
- Release the clips (x2) on the back of the armrest closeout panel first, and then pull the panel outward to release other clips and lower tabs (x2) and finally lift up the panel to remove it from the LH seat frame.NOTE: Using a plastic trim tool is recommended. Replace the clips if they are damaged during removal.WARNING: The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.multimedia:A supplement to the article is available.