LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2024 >> Model 3 Long Range >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seats -- Model 3 >> 2nd Row Seat Assemblies and Hardware >> 2nd Row Seat Back Hardware - 2nd Row Trim - Black Armrest Close Out Assembly - Remove And Replace >> Install

2nd Row Seat Back Hardware - 2nd Row Trim - Black Armrest Close Out Assembly - Remove And Replace: Install

  1. Slide the 2nd row armrest closeout panel down first to engage the lower tabs (x2) to the seat frame, then press the panel inwards to secure all other clips.
    WARNING: The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.
    multimedia:A supplement to the article is available.
    G16589038Courtesy of TESLA, INC.
    G16589039Courtesy of TESLA, INC.
    NOTE: Ensure that all clips are not damaged and installed in place.
  2. Fold the 2nd row armrest back.
    G16589040Courtesy of TESLA, INC.
  3. Install the rear trim cover to the seat back.
    NOTE: Engage the clip strips of the seat back trim cover to the seat frame.
    G16589041Courtesy of TESLA, INC.
    G16589042Courtesy of TESLA, INC.
    G16589043Courtesy of TESLA, INC.
  4. Zip the seat back trim cover.
    G16589044Courtesy of TESLA, INC.
  5. Install the 2nd row LH seat back. See 2ND ROW SEAT ASSEMBLIES - 2ND ROW SEATBACK - LH - REMOVE AND REPLACE .
  6. Install the 2nd row lower seat cushion. See 2ND ROW SEAT ASSEMBLIES - 2ND ROW SEAT CUSHION - REMOVE AND REPLACE .
  7. Install the 2nd row LH seat side bolster. See 2ND ROW SEAT ASSEMBLIES - 2ND ROW BOLSTER - LH - REMOVE AND REPLACE .
scientia non olet · About LEMON Manuals